- HELP
EVCGA is the first of four Repair Level Diagnostics for the
CI780. It is comprised of thirty-one tests.
To run EVCGA, boot in the Diagnostic Supervisor, load
EVCGA.EXE, and attach as follows:
For a Vax 11/780 or 11/785:
'ATTACH CI780 SBI PAA0 14 4 0',
where 14 is the TR number,
4 is the BR level, and
0 is the node number.
For data on attaching, type 'HELP EVGAA ATTACH_CI780' (for
a CI780 on a 11/780 and 11/785) or 'HELP ATTACH_CI780_8600'.
Each time information is desired on the following keywords
it is necessary to type HELP EVGAA 'keyword'.
- ATTACH_CI780_8600.
ATTACH SBIA HUB SI0 ; If SBIA1 is used, attach SI1
; instead of SI0
ATTACH CI780 SI0 PAA0 14 4 0 ; attaches CI780 to VAX 8600
SELECT PAA0 ; selects device to be run
Device: CI780
Link: SI0/SI1
Recommended generic: PAa0
Additional information:
TR Number: [decimal 1-15] determined by BP jumpers
BR Level: [4-7] determined by BP jumpers
Node Number: [decimal 0-255] switch select on Link Bd
Note that the node number set on the Link Bd should agree with
the node number used in the Attach Command.
- ATTACH_CI780
; On a VAX 11/785 it is attached in the
; same way as the Vax 11/780
ATTACH CI780 HUB PAA0 14 4 0 ; attaches CI780 to 11/780
SELECT PAA0 ; selects device to be run
Device: CI780
Link: HUB/SBI
Recommended generic: PAa0
Additional information:
TR Number: [decimal 1-15] determined by BP jumpers
BR Level: [4-7] determined by BP jumpers
Node Number: [decimal 0-255] switch select on Link Bd
Note that the node number set on the Link Bd should agree with
the node number used in the Attach Command.
- SECTIONS
Sections names have been generated for tests that test
common hardware and/or similar functions. The user can run
any individual section by typing START/SECTION:SECTION NAME
The following sections are available in EVCGA:
REGISTER - CNFGR, PMCSR,MADR,MDATR Registers
LS_VCDT - Local Store/VCDT Tests
CONTROL_STORE - Control Store Tests
IB_SRC_DST - Bus IB Source and Dest Tests
- WCS
Provisions exist in the program to allow testing of CS Ram
size of 2k or 3k. The program default condition is for 2k
of CS Ram. If 3k of CS Ram exits the user should Set Event
Flag #5 before starting the program. This action will load
new values into the initialization code to test the following
tests for 3K of CS ram:
Control Store - Read/Write Ram Test (EVCGA)
Control Store - Dual Address Test (EVCGA)
2911 Sequencer UPC + 1 Test (ESCGB)
To set Event Flag 5, type 'SET EVENT 5'.
To clear Event Flag 5, type 'CLEAR EVENT 5'.
- EVENT_FLAGS
EVENT FLAG 5 is used to change the WCS tests for 3K.
To set Event Flag 5, type 'SET EVENT 5'.
To clear Event Flag 5, type 'CLEAR EVENT 5'.
Type 'HELP EVCGA WCS' for more information.
- QUICK
The QUICK feature is not implemented in this diagnostic.
The diagnostic execution time for EVCGA is 90 seconds.
- SUMMARY
No SUMMARY report is issued by this program.