- ATTACH
Each CPU must be attached with the following command:
DS> ATTACH KA820 HUB KAn msiz id
where:
n is different for each CPU (normally, the operator would start
with 0 and increment for each attached processor)
msiz is the size of memory in kbytes <decimal>
Note: If 0 is specified for memory size, the program will
size for memory and print the result in test 25. It will
not result in an error and all available memory found will
still be tested in all memory tests.
id is the CPU node's ID <Hex>
DS> SEL KAn
The SEL must be done for each processor, or simply type SEL ALL.
- HELP
This program tests portions of the VAX KA820 CPU which are
used in Multiprocessor applications and can not be tested
in a uniprocessor environment. It requires at least two CPUs
(a primary processor and one or more attached processors).
This program must run in a standalone environment under control
of the Diagnostic Supervisor.
NOTE: This program will only run from the primary processor.
Attempting to run from an attached processor via the B node
command will result in errors. All processors are tested
concurrently when this diagnostic is started on the primary.
Type HELP EBKMP ATTACH for attach details.
- SECTIONS
By default, all tests are run.
- DEVICE
The diagnostic supports the following devices:
Two or more VAX KA820 CPUs
- EVENT
No event flags are used in this diagnostic.
- QUICK
Not implemented (execution time per pass is about 5 seconds).
- SUMMARY
Not Implemented